English

Go Back   Champions of Regnum > English > Technical Support

Technical Support Questions about game technical support to the users of the community

Reply
 
Thread Tools Display Modes
Old 06-21-2011, 05:39 AM   #61
Nils_Dacke
Initiate
 
Join Date: Jan 2009
Posts: 172
Nils_Dacke is an unknown quantity at this point
Default

A more powerful PSU also produces less heat than one with lower specs, at the same load. (switched PSU's anyway)

Just for the record: there is a pin on the connector named PS_ON (Green wire, pin 14 on the ATX connector. See the pinout for the ATX connector.)

That pin is a signal from the motherboard to the PSU to go out of standby mode and turn on all voltages (PS_ON low) or vice versa (PS_ON high). This signal is a common source of trouble as different manufacturers have implemented it slightly differently. Some motherboard implementations of power save mode logic and BIOS are also simply buggy.

What one can try if suspecting a miscommunication on PS_ON, after making sure that the PSU isn't simply overloaded (check the voltages) is to simply shorthen this pin to nearest GND (black wires, 13 or 15 is nearest). You don't have to cut any wires. It's just a pull up resistor there so shortening the pin to GND won't damage anything. This will inhibit the motherboard, electrically, from shutting down the PSU.
__________________
Apart from that, dispell magic on oneself should be abolished.
Nils_Dacke no ha iniciado sesión   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 01:00 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
NGD Studios 2002-2016 © All rights reserved